Electronic Load Module | - 9KW(Water Cooling Type) - 600A, 1000A - 60V, 120V, 400V |
---|---|
Floor Standing Case |
- Housing Cabinet - Including all required hardware & connection fittings - keyboard & Monitor Arm - Power 3상 220VAC or 380VAC, Max 75A - 1100(W)x 1800(D) x 2000(H)mm |
Mass Flow Controller |
- Anode: H2, N2, Max150 SLPM - Cathode: Air, N2, Max 450LPM |
Humidity Bottle Assembly |
- Bubble or Membrane humidification type - Gas 온도 Control, 물온도 측정 - 고온용 float(Level) switch - Wet & Bypass Mode |
Automatic Water Fill | - Humidifier에 DI Water 자동 공급 |
Stack heating & Cooling Water Circulation |
- Tank 50L - Heating(Max 90도) & Cooling(냉각수 열교환) System - Circulation Flow Auto Control - Water Conductivity Monitoring |
DI Water Filter System |
- 초순수 제조 Filter 시스템 내장 - 자동 생산 |
Auto Back Pressure Control & Monitoring |
- Max 3.5bar Control - Pressure Proportional Control Valve & 제어 - Low Pressure Drop 0~2Kpa at Max flow - Differential Pressure Control 기능 - Stack In&Out(H2, Air) Pressure monitoring |
Preheater(Line Heater) |
- Flexible Sus 편사튜브, Anode 1/2" & Cathode 3/4" - Direct Gas 온도 Control |
Water Trap |
- 응축수 자동 분리배출 - Heat Exchanger & Cooling Water |
Operation Software |
- LabView Programming - 다양한 Fuel Cell Operating 프로그램 - 실시간 Data display & DAQ - Auto Protocol Test - Flow Tracking(Load Following) 기능 - 기타 사용자 요구사항에 따른 프로그램 구현 |
Cell Voltage Monitoring |
- ±3V/Cell - 채널수 선택 |
---|---|
Single or Multi Channel AC Impedance Measurement System |
- Load연동형 장비일체형, IV 시험과 동시에 HFR측정 - Frequency Range 0.01Hz~10KHz - 채널수 선택 |
Stack 방전 기능 |
- 선택적 1~2kW 방전저항 Relay구성 |